Instructions:
Remove the battery from the node.
Flash the Nodes with correct Firmware.
Wait until the “All nodes firmware up-to-date” test passes.
How to Flash a Node with a Portable Flasher:
Turn on the flasher.
Plug the cable in the node and hold it there.
Pick the appropriate firmware to be flashed by selecting "SEL" → Select by pressing "PROG".
The Sequence of the Installation:
Install Thermostat first → Do the degree test.
Install Occupancy /Door sensors → Do the test.
When to Replace a Node:
Put the battery on- Node should come online and join in 15-20 seconds, otherwise, it has an issue.
Do the following steps:
A. Unmap and remap the node (Wait for 15 seconds)
B. Take the battery out and reinsert it (Wait for 15 seconds to join)
C. Still not joining? Replace it. Follow this link: How to Replace
Troubleshooting Steps (for SensorFlow):
Use “Site Visit Info” while the installation is going on. Follow this link: Site Visit Info
For checking the correct Firmware version, use the SF dashboard. Login with “Project Coordinator” ID.
It may take a while to update the FW in the portal. Try refreshing the page if it still shows the old version.
No Gateway restart unless coordinated that everyone is outside the rooms.